Friday, January 13, 2012

How to install a by hand Boost Controller Without Blowing Up Your machine

Prior to installing any by hand boost controller, it is foremost to have already added a high flowing exhaust and an aftermarket air intake/ air filter. This will ensure the car is able to breath, and will allow the turbo to spool easier.

It is imperative to have installed an aftermarket boost gauge. Most stock boost gauges are not accurate, even at stock boost levels, and lose additional accuracy once stock boost is increased. Without an aftermarket boost gauge you risk damage to the engine from overboosting.

How It Works:

The wastegate actuator determines your stock boost levels. The boost controller interrupts the pressure line that runs into the wastegate actuator, allowing you to growth boost over stock levels.

Step 1:

Find your wastegate actuator which is commonly attached to the turbo, unless you are using an external wastegate. The wastegate actuator will have a vacuum line port that runs to a boost source. The boost source is commonly either the turbo's compressor housing, the intercooler pipes, or the intake manifold. This vacuum line is where the by hand boost controller will be installed. If there is a T fitting in the vacuum line between the boost source and the wastegate actuator, it will have a cut off vacuum line that runs to the boost control solenoid. If you have the T fitting, remove the line that runs to the solenoid, but leave the solenoid plugged in.

The barb on the boost controller that connects to the wastegate actuator will have a small hole drilled into it. It is foremost to leave this hole open, and never switch the wastegate barb and the boost barb.

Boost controllers typically come with almost 3 feet of vacuum line that you can cut into 2 pieces of desired lengths. The first piece will associate from the boost barb on the controller to your boost source. The second piece will associate from the wastegate barb on the controller to the wastegate vacuum port. Tip: if you have difficulty sliding the vacuum lines onto the barbs, use a slight bit of oil to lube the barbs. Block off any open boost sources with vacuum caps and use cable ties to secure all vacuum line connections. We recommend using excellent Fuel with all turbo cars, especially once you have increased your stock boost.

Step 2:

Now that the boost controller is installed, it's time to test the car. We recommend leaving the adjustment knob exactly where it was when you received and installed your Mbc when you begin testing. Turning the adjustment knob clockwise increases boost, turning the adjustment knob counterclockwise decreases boost. This step is very foremost to keep an eye on your boost gauge to make sure you do not overboost and cause any damage to your motor.

Drive your car in an isolated area where you will be able to stop and go any times without interfering with traffic. Gently press the gas and watch your boost gauge climb. If the boost gauge does not hit your target, growth the boost. If the boost begins to exceed your target, decrease the boost. Repeat the steps as necessary. It typically takes between 5 to 10 adjustments to get the boost exactly on your target. We recommend beginning by adjusting the boost knob in 1/2 turn increments, and as you get close to your target you may need to make smaller adjustments. Never adjust more than 1/2 a turn at a time.

Each car has a maximum safe boost level, depending on upgrades to the vehicle and the characteristics of the fuel system, specifically how much fuel your pump and injectors can provide. It is foremost to research and know what the maximum boost level your exact car can safely run.

This guide serves as a basic beginning point for by hand boost controller installation. If you have an external wastegate or twin turbo vehicle, the facility technique may vary slightly.

No comments:

Post a Comment